Operation - Klarstein Smartwave Mode D'emploi

EN
28

OPERATION

Warning: Danger of personal injury
This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they
are occupied by persons not capable of leaving the room on
their own, unless constant supervision is provided.
1. Plug the heater power cord into the socket that matches the voltage and current of
the body nameplate.
2. Press the On/Off button to open the heater.
3. Press the Power Select button to select the gear position, a total of four gear power
selection, the gear position indicator icon displays the corresponding gear position
symbol.
4. Press the Up/Down button to select the setting temperature. The temperature setting
range is 5-45 degrees.
5. Press the Timer button to enter the timing setting state. Select the timed shutdown
time by the up/down button. The timing range is 0-24 hours. The timing indicator is
illuminated when the timer is running.
6. Press the Display button once, the digital screen only displays the room
temperature, and press the Display button twice to display only the heating symbol.
7. Press the Smart heating button, the heater enters the intelligent heating mode, the
gear position will automatically switch according to the temperature change, and
the intelligent heating operation indication icon will light when the intelligent heating
mode is running.
8. According to the Body sensor button, the heater enters the human body sensing
mode, and the heater heats up when the warming device detects a moving object.
Not detected, the heater stops heating after two minutes, and the body sensing
operation indicator lights up when the human body sensing mode is running.
9. Press the Set button and then press the child lock button, the heater is locked, press
any button, no response.
Unlock: Press the toggle button and then the child lock button.
10. Press the Set button and then press the up button to switch between Fahrenheit and
Celsius.
1 1. Press the Set button and then press the button to reset the WI-FI.
12. Press the Set button and then press the gear button to select the window detection
function. When the window detection function is running, the WO lights up. When
the heater detects that the ambient temperature drops by 3 degrees Celsius or
more in two minutes, it stops heating. At this time, the window detection operation
indication icon is lit.
13. Press the Set button and then press the Display button to display the voltage.
14. Press the On/Off button again to shut down.