Grillo PK 600 Manuel D'utilisation page 12

This table is intended to help you to keep your machine in good, safe working order. It lists the main maintenance and
lubrication procedures with the frequencies at which they are required. Alongside each one, you will find a series of
boxes where you can note the date or the number of operating hours when the procedure was carried out. CAUTION!
Perform the first general inspection after the running-in period, after the first 50 working hours. Change the
engine oil and filter.
Then follow the table below:
PROCEDURE
Check the wheel bolts tightness
Check the rubber hoses (brakes, feed system and hydraulic
system)
Check the tyre pressure
Check the brakes wear
Check the battery voltage
Check the engine, gearbox and pipe
Check and clean the engine air filter
Check the brake fluid level
Check the radiator liquid level
Check the gearbox oil level
Check the engine oil level
Change the radiator fluid
Change the engine oil
Change the brakes fluid
Change the air filter
Change the fuel filter
Refer to the engine handbook for the complete list and relative procedures.
General lubrication is strongly recommended whenever the machine is to be out of use for a long period.
recommended procedure
* procedure to be made if necessary
ROUTINE MAINTENANCE GUIDE
ROUTINE MAINTENANCE GUIDE
AFTER EACH
EACH 8
THE 50 100
HOURS
HOURS HOURS
•
•
•
•
•
•
•
•
•
•
11
EACH
250
EACH HOURS
200 ORE OR
EACH
YEAR
•
•
•
•
•
•
*
•