EdilKamin MEG PIU Installation, Usage Et Maintenance page 38

MAINTENANCE
Before performing any maintenance, disconnect the applian-
ce from the mains.
Regular maintenance is required for the boiler-stove to fun-
1
ction correctly.
Any problems resulting from lack of maintenance will imme-
3
diately void the warranty.
When cleaning is necessary, the message "Clean - exchan-
ger" will appear on the panel if further cleaning is necessary.
NOTE: The DEALER, upon commissioning, sets the kg value
2
of consumed pellets; after which, the message "SERVICE
UTE" will appear on the display. The boiler-stove continues
operation, but the end client is invited to perform careful
maintenance, described above and explained by the DEALER
fi g. A
during commissioning, to the extent of his abilities.
Once the maintenance work has been performed, press and
hold down the "M" button on the radio remote control for at
least 5 seconds to delete the message displayed on the screen
(this operation must be performed with the thermo-stove off).
N.B.
- Any unauthorised modifi cation is forbidden
- Use spare parts recommended by the manufacturer
- The use of counterfeit parts results in the guarantee beco-
ming null and void
*
DAILY MAINTENANCE
Operations must be performed when the boiler-stove is off,
cold and unplugged from the power supply.
Cleaning should be carried out with the aid of a vacuum clea-
ner (see optional page. 43), the whole procedure takes up a few
minutes.
fi g. B
• Open the door, remove the combustion chamber (1 - fi g. A) and
empty the residue out into the ash pan.
• Scrap the combustion chamber with the spatula provided,
removing any obstructions in the openings.
• DO NOT EMPTY THE RESIDUE OUT INTO THE PEL-
LET HOPPER.
• Take out and empty the ash (2 - fi g A) pan into a fi reproof con-
tainer (the ash may still contain hot parts and/or embers).
• Vacuum clean the inside of the fi replace, the fi re surface, the
compartment around the chamber where ash falls, and the ash
pan.
• Vacuum the combustion chamber holder, clean the edges where
the combustion chamber is lodged into its seat.
• Clean the glass, if necessary (when cold).
4
AT LEAST ONCE A DAY ACTION THE CLEANING
BRUSHES OF THE EXCHANGERS (*), EVEN WHILE
THE STOVE IS LIT, USING THE GLOVE PROVIDED:
fi g. C
- Proceed by shaking the cleaning handle positioned under the
front-top grill (fi g. B).
4
4
NEVER SUCTION HOT ASH, as this could damage the
suction device and possibly cause a fi re.
ATTENTION:
MAKE SURE THE ASH PAN IS CORRECTLY POSITIO-
NED IN ITS HOUSING (2 fi g. A)
WEEKLY MAINTENANCE
• Clean the hearth (with the tube brush).
NO
YES
• Vacuum the pipe near the electric coil (3 - fi g A).
• Remove the ceiling (4 - fi g. C) and tip the residue into the ash
drawer (2 - fi g. A).
- 38
-