Connect Power; Pairing The Wireless Subwoofer With The Main Unit; Automatic Pairing; Manual Pairing - Altec Lansing AL-SNB301W-001-SNOW Mode D'emploi

Connect Power

Caution:
Risk of product damage! Ensure that the power
supply voltage corresponds to the voltage printed
on the back or the underside of the unit.
Before connecting the AC power cord, ensure you
have completed all other connections.
1. Connect the mains cable to the AC~ Socket of
the unit and then into a mains socket
2. Connect the mains cable to the AC~ Socket of
the subwoofer and then into a mains socket.
Note: Besure to unplug the power cord from the
outlet when the system is not in use for an extended period of time.

Pairing the Wireless Subwoofer with the Main Unit

Automatic pairing

The subwoofer and soundbar will automatically pair when both units are plugged into the mains sockets and
turned on. No cable is needed for connecting the two units.
• When the subwoofer is pairing with the main unit, the Pair Indicator will flash fast.
• When the subwoofer is paired with the main unit, the Pair Indicator will light up.
NOTE:
Do not press the Pair button on the rear of the subwoofer, except for manual pairing.
If the automatic pairing fails, pair the subwoofer with the main unit manually.

Manual pairing

1. Ensure that all the cables are well connected and the main unit is in Standby mode.
2. Press and hold the Pair button on the rear of the subwoofer for a few seconds. The subwoofer will enter
the pairing mode and the Pair Indicator will blink quickly.
3. Press the button on the main unit or on the remote control to switch the main unit on.
4. After the wireless connection succeeded, the Pair Indicator will light up.
5. If the Pair indicator blinks, the wireless connection has failed. Unplug the cable of the subwoofer and then
reconnect the main cable after 3 minutes. Repeat step 1 to 4.
NOTE:
• If the wireless connection fails again, check if there is conflict or strong interference(for example,
interference from an electronic device) around your location. Remove these conflicts or strong
interferences and repeat the above procedures.
• The subwoofer should be within 6m of the soundbar in an open area.
• If a connected TV or external device is switched on, the main unit (only AUX or MP3 LINK mode) and
the subwoofer will switch on automatically.
• If the main unit is not connected with the subwoofer and it's at On mode, the POWER Indicator will flash.
Follow step 1 to 4 above to pair the subwoofer to the main unit.
9