Preparations; Prepare The Remote Control; Replace The Remote Control Battery - Altec Lansing AL-SNB301W-001-SNOW Mode D'emploi

Preparations

Prepare the Remote Control

The provided Remote Control allows the unit to be operated from a distance.
Even if the Remote Control is operated within the effective range (6m), remote control operation may be
•
impossible if there are any obstacles between the unit and the remote control.
If the Remote Control is operated near other products which generate infrared rays, or if other remote
•
control devices using infra-red rays are used near the unit, it may operate incorrectly. Conversely, the other
products may operate incorrectly.
First-time use:
The unit has a pre-installed lithium CR2025 battery. Remove the protective tab to activate the remote control
battery.

Replace the Remote Control Battery

1 Pull out the battery tray and remove the old battery.
2 Place a new CR2025 battery (not included) into the battery tray with correct polarity (+/-) as indicated.
3 Insert the battery tray back into the slot.
Precautions Concerning Batteries
When the Remote Control is not to be used for a long time (more than a month), remove the battery from
•
the Remote Control to prevent it from leaking.
If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with
•
new ones.
Do not use any batteries other than those specified.
•
Do not heat or disassemble batteries. Never throw them in fire or water.
•
Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short circuit,
•
leak or explode.
Never recharge a battery unless it is confirmed to be a rechargeable type.
•
7