Care And Maintenance; Technical Description Of The Models - SCHOLTES TIS 744 DD L S Mode D'emploi

Care and maintenance

Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
Do not use abrasive or corrosive detergents
!
(for example, products in spray cans for cleaning
barbecues and ovens), stain removers, anti-rust
products, powder detergents or sponges with abrasive
surfaces: these may scratch the surface beyond repair.
Never use steam cleaners or pressure cleaners on the
!
appliance.
• It is usually sufficient simply to wash the hob using
a damp sponge and dry it with absorbent kitchen
towel.
• If the hob is particularly dirty, rub it with a special
glass ceramic cleaning product, then rinse well and
dry thoroughly.
• To remove more stubborn dirt, use the scraper
provided. Remove spills as soon as possible,
without waiting for the appliance to cool, to avoid
residues forming crusty deposits. You can obtain
excellent results by using a rust-proof steel wire
sponge - specifically designed for glass ceramic
surfaces - soaked in soapy water.
! The scraper provided is sharp: be careful when using
it.
• If any plastic or sugary substances are accidentally
melted on the hob, remove them immediately with
the scraper, while the surface is still hot.
• Once it is clean, the hob may be treated with
a special protective maintenance product: the
invisible film left by this product protects the surface
from drips during cooking. This maintenance task
should be carried out while the appliance is warm
(not hot) or cold.
• Always remember to rinse the appliance well with
clean water and dry it thoroughly: residues can
become encrusted during subsequent cooking
processes.
Stainless steel frame (only in models with outer frame)
Stainless steel can be marked by hard water which has
been left on the surface for a long time, or by cleaning
products containing phosphorus.
After cleaning, it is advisable to rinse the surface well
and dry it thoroughly. If water is spilt on the surface,
dry it quickly and thoroughly.
! Some hobs have an aluminium frame which is
similar to stainless steel. Do not use any cleaning or
degreasing products which are not suitable for use
with aluminium.
Disassembling the hob
If it is necessary to disassemble the hob:
1. Loosen the screws fixing the alignment springs on
each side.
2. Loosen the screws holding the fixing hooks in each
corner.
3. Take the hob out of its installation cavity.
Do not attempt to repair the appliance yourself. If the
!
appliance breaks down, contact a Service Centre.

Technical description of the models

The induction system is the quickest existing way
of cooking. Unlike traditional hotplates where the
cooking zone heats up, with the induction system
heat is generated directly inside pans which have
ferromagnetic bases.
Key:
I = single induction cooking zone
IDD = double-diameter induction cooking zone
B = booster: the power of the cooking zone may be
boosted to 3000 W
* = the maximum power level is limited while the
booster is activated for the relevant rear cooking
zone (see Start-up and use).
Hobs
Cooking zone
Back Left
IDD 2200 – B 3000* - 1600 if front right*
Back Right
IDD 2200 – B 3000* - 1600 if back left*
Front Left
I 1400 – B 2000* – 600 if back right*
Front Right
Total power
TIS 744 DD L S
Power (W)
I 1400 – 600 if front left*
7200
19
GB