dirna Bergstrom Bycool DINAMIC 1.1 Instructions De Montage page 24

DINAMIC 1.1
EN
PRIOR OPERATIONS:
• Disconnect the battery.
• Dismantle inner air distribution panel from evaporator
unit.
INSIDE THE CABIN:
1
Position the supplied template on the top bunk,
laterally aligned and approximately 30 mm
from the cabin roof, and mark the boreholes.
30
(*) Make a Ø4 through bore with long broach in
2
bore position Ø48, and then make the following
bores.
A- Make (1) Ø35 in the upholstery only
B- Make (1) Ø19 in the upholstery only
C- Make (1) Ø48 in the upholstery only
D- Make (4) Ø22 in the upholstery only
*
1
1
2
2D
24
UP
UP
2C
®
UP
Ø48
Ø35
Ø19
UP
Ø48
*
Ø35
Ø19
2D
2A
2B