Philips SensoTouch RQ1200 Série Mode D'emploi page 26

ENGLISH
26
26
Problem
RQ1296CC,
RQ1295CC,
RQ1290CC,
RQ1286CC,
RQ1285CC,
RQ1284CC,
RQ1280CC,
RQ1275CC,
RQ1265CC,
RQ1260CC,
RQ1252CC,
RQ1251CC,
RQ1250CC only: The
shaver is not entirely
clean after I clean it in
the Jet Clean System.
The Jet Clean System
does not work when
I press the on/off
button.
The shaver is not fully
charged after I charge
it in the charger/Jet
Clean System.
Possible cause
The cleaning fluid in the cleaning chamber
is soiled.
The cleaning fluid level is too low. If the
fluid volume in the cleaning chamber drops
below the minimum level during the cleaning
program, the program aborts.The cleaning
light and the 'cleaning chamber empty'
symbol flash at intervals and the holder
returns to its starting position.
You have used another cleaning fluid than
the original Philips cleaning fluid.
The Jet Clean System is not connected to
the mains.
You have not placed the shaver in the
Jet Clean System properly, so there is no
electrical connection between the Jet Clean
System and the shaver.
You have not placed the shaver in the
charger/Jet Clean System (specific types
only) properly.
Solution
Empty and rinse the cleaning
chamber and refill it with new
cleaning fluid.
Refill the cleaning chamber with
cleaning fluid to a level between
the two lines (see chapter
'Cleaning and maintenance').
Only use HQ200
Philips Cleaning Fluid.
Put the small plug in the Jet
Clean System and put the
adapter in the wall socket.
Press the shaver tightly into the
holder to lock it into place.
Make sure you press the shaver
until it locks into place.