Hitachi C 7SB2 Instructions De Sécurité Et Mode D'emploi page 10

English
36. Blades and accessories must be securely mounted to the tool.
Prevent potential injuries to youself or others. Blades, cutting implements and accessories
which have been mounted to the tool should be secure and tight.
37. Never use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise appears
defective, stop using it immediately and arrange for repairs by a Hitachi authorized
service center.
38. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.
39. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dried
thoroughly.
40. Never wear gloves made of material liable to roll up such as cotton, wool, cloth or
string, etc.
41. Definitions for symbols
V ............ volts
Hz .......... hertz
A ............ amperes
no .......... no load speed
.......... Class II Construction
---/min ... revolutions per minute
.......... alternating or direct current
10