Husqvarna K 7000 Manuel D'utilisation page 23

To clean externally
CAUTION: Do not use a high-pressure
washer to clean the product.
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can become damaged.
• Examine the electrical parts for damage. Do not
operate a product that has damaged electrical parts.
To adjust the tension of the drive belt
The tension of the drive belt is correct when the
adjustment nut is opposite the mark on the drive belt
cover.
Tighten a new drive belt after 1 hour of operation.
1. Loosen the 2 bolts that hold the cutting head to the
cutting arm.
1448 - 003 - 13.02.2020
2. Turn the adjuster screws until the adjustment nut is
opposite the mark on the drive belt cover.
3. Use a combination wrench and tighten the 2 bolts
that hold the cutting head to the cutting arm.
To replace the drive belt
1. Turn the bolt for the cutting blade counterclockwise
with a wrench to remove the cutting blade.
2. Loosen the 2 bolts and then the adjuster screw to
release the belt tension.
3. Remove the 2 bolts and remove the belt guard.
23