Functional Description; Removing/Inserting The Battery - Milwaukee Tool FORCELOGIC M18 2776R-20 Manuel De L'utilisateur

FUNCTIONAL DESCRIPTION

5
3
2
4
1
15
1. Blade retainer
2. Blades
3. Front handle
4. Grounding lug
5. Trigger lock
6. LED
14
7. Trigger
8. Release trigger
9. Handle
10. ONE-KEY battery
door
11. Remote cut light
SPECIFICATIONS
Cat. No. ...................................................2776R-20
Volts .............................................................. 18 DC
Battery Type .................................................M18™
Charger Type ................................................M18™
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
High Voltage Field Rating ........................... 34.5 kV
Max Capacity *
†
Single Conductor ................1500 MCM Cu, 15KV
3 Conductors .......................350 MCM Cu, 15 KV
3 Conductor Single Cable............3x500 MCM Cu
* Do Not Cut Steel
In Remote Mode, only make Single Conductor cuts
†
Replacement Blades .............. Cat. No. 49-16-2774
Remote Cat. No. ................................. 22-80-2776
Volts ...................................... 6 DC (1.5 V AA x 4 )
6
7
9 10
8
11
16
17
12. Remote cut switch
13. Hanger
14. Remote power switch 1
15. Remote button 2
16. Remote button 3
17. Remote cut indicators
1500 MCM Al, 46KV
3x750 MCM Al
WARNING
cific charging instructions, read the operator's
12 manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
13
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Blades are sharp. Keep hands away from cutting
edge. Laceration can occur.
Replace the blades when they become chipped or
damaged. Always replace blades as a set. Use only
MILWAUKEE blades. Refer to Specifications for
replacement blade numbers.
1. Pull the trigger to close the blades slightly. The
retaining rings must be exposed.
2. Remove the battery pack.
3. Use a wrench or pliers to remove the blade nut
and remove the blade bolt. Discard the blade nut.
4. Remove the retaining ring and pull out the pin
from one of the blades.
5. NOTE: Take notice of the blade orientation so the
new blades can be installed the same way. The
blades should be oriented so the flat sides contact
and the bevels face away from each other, like a
pair of scissors.
6. Carefully remove the blade.
7. Install the new blade in the same
orientation.
8. Slide the pin through the blade
and bracket. Replace the retaining ring.
9. Repeat steps 4 to 8 for the other blade.
10. Insert the blade bolt.
11. Thread the new blade nut onto the blade bolt.
Tighten the nut to 150 in-lbs, then back it off
between 1/4 and 1/2 turn.
NOTE: To ensure proper installation, perform a test
cut. If the blades bind when opening, loosen the blade
nut slightly until the blades no longer bind.
Locking and Unlocking the Trigger
To lock the trigger, pull the trigger lock back.
To unlock the trigger, push the trigger lock to the
center position.
To lock for remote cut, pull the trigger and push the
trigger to the
release.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others
Changing the Blades
position. Pull the trigger again to
Retaining ring
Flat side of blade