Fault Finding Chart; Error Codes - BH HIPOWER G550 Instructions De Montage Et Utilisation

FAULT FINDING CHART

PROBLEM
1. The monitor does not
switch on.
2. The monitor switches
on but the motor fails to
start.
3. Walking motion is jerky
on the treadmill.
4. The machine stops (the
breaker trips).
5. Electrical
through the handrail.
6. The treadmill
skews off centre.

ERROR CODES

Monitor screen displays E1
Monitor screen displays E2
Monitor screen displays E4
Monitor screen displays E6-E7
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on
the sliding belt.
3.c) Check the tension on
the drive belt.
4) Check that the band is
lubricated.
shocks 5) Check that the machine
is plugged into an earthed
mains socket.
belt 6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
CHECKS
- Possible motor overload.
- Lubricate the belt.
- Switch the machine off and on again.
- Body fat function fault.
- Restart the machine and place your
hands correctly for a pulse rate reading.
- Elevation fault.
20
SOLUTIONS
1) Plug the machine into the
mains supply.
switch to position 1 and
insert the safety key.
2) Switch the machine off
and press the
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
4) Reset the
button with the On /Off
switch at „0" and lubricate
the treadmill band.
5) Plug the machine into an
earthed mains socket.
Set the
circuit
overload