Fault Finding Chart; Error Codes - BH HIPOWER G550BM Instructions De Montage Et Utilisation

FAULT FINDING CHART

PROBLEM
1. The monitor does not
switch on.
2. The monitor switches on
but the motor fails to start.
3. Walking motion is jerky
on the treadmill.
4. The machine stops (the
breaker trips).
5. Electrical shocks through
the handrail.
6. The treadmill belt skews
off centre.

ERROR CODES

Monitor screen displays E1
Monitor screen displays E2
Monitor screen displays E4
Monitor screen displays E6-E7
Do not hesitate to get touch with the Technical Assistance Service if you have any queries by phoning
customer services (see last page in manual).
CHECKS
1) Make sure that the machine
is plugged in, the ON/OFF
switch in position 1 and that
the safety key is inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
4) Check that the band is
lubricated.
5) Check that the machine is
plugged into an earthed mains
socket.
6.a) Check that the machine is
level on the floor.
6.b) Check that the machine
does not wobble.
- Possible motor overload.
- Lubricate the belt.
- Switch the machine off and on again.
- Body fat function fault.
- Restart the machine and place your hands
correctly for a pulse rate reading.
- Elevation fault.
16
SOLUTIONS
1) Plug the ma chine into the
mains supply. Set the switch
to position 1 and insert the
safety key.
2) Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload button
with the On /Off switch at „0"
and lubricate the treadmill
band.
5) Plug the machine into an
earthed mains socket.