Replacement Accessories - DeWalt DCST920 Guide D'utilisation

To accelerate the trimmer, pull the speed control switch
back toward the battery housing
This mode is best to cut through heavier growth and for
applications that need higher RPM.
NOTE: When in "HI" mode, runtime will be decreased as
compared to when trimmer is in "LO" mode.
Trimming (Fig. K, L)
With the trimmer on, angle it and swing side to side as
shown in Figure K.
Maintain a minimum distance of 24 inches (610 mm)
between the guard and your feet as shown in Figure L.
Fig. K
Fig. L
Minimum
24 Inches (610 mm)

WARNING:
roughly parallel with the ground (tilted no more than
30 degrees). This trimmer is not an edger. DO NOT
TILT the trimmer so that the string is spinning near
a right angle to the ground. Flying debris can cause
serious injury.
Bump Feed Trimmer Line Feed
Your trimmer uses 0.080 inches (2.032 mm) diameter nylon
line. Cutting line will wear faster and require more feeding
if the cutting is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut.
As you use the trimmer, the string will get shorter due
to wear. Gently bump the trimmer on the ground while
running at normal speed and the line will feed.
nOTE: Extending nylon line beyond the 13 inch (330 mm)
swath will negatively affect performance, runtime, and the
life of the trimmer due to potential of damaging motor.
Doing so may void the warranty.
Helpful Cutting Tips
• Use the tip of the string to do the cutting; do not force
string head into uncut grass.
11 into the "HI" position.
Keep the rotating string
• Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs, and wood may
wear string rapidly.
• Do not allow spool cap to drag on ground or
other surfaces.
• In long growth, cut from the top down and do not
exceed 12 inches (304.8 mm) high.
• Keep trimmer tilted toward the area being cut; this is
the best cutting area.
• The trimmer cuts when passing the unit from the left to
right. This will avoid throwing debris at the operator.
• Avoid trees and shrubs. Tree bark, wood moldings,
siding, and fence posts can easily be damaged by
the string.

Replacement Accessories


WARNING:
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
or accessories.

WARNING:
recommended by D WALT for use with this appliance
e
could be hazardous.

WARNING:
or any accessory or attachment other than those
recommended by D WALT on this trimmer. Serious
e
injury or product damage may result.
Use D WALT replacement line Model No. DWO1DT801
e
or DWO1DT802.
When replacing the line, use only .080 inches (2.032 mm)
diameter line (Model No. DWO1DT801 or DWO1DT802 are
is recommended). Other sizes may degrade performance or
cause damage to the trimmer.
Reloading the Cutting Line (Fig. A, M, N)

WARNING:
serious personal injury, turn unit off and remove
the battery pack. An accidental start-up can
cause injury.

CAUTION:
spools and line. Using any other manufacturer's line
can reduce performance, damage the trimmer or
cause personal injury.
Your trimmer uses 0.080 inches (2.032 mm) diameter
line. Do not use other size lines. This can degrade
performance, cause damage to the unit or injury

CAUTION:
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
Use only D WALT replacement line.
e
1. Remove battery.
English
To reduce the risk
The use of any accessory not
Do not use any blades,
To reduce the risk of
Use only D WALT replacement
e
To avoid appliance damage, if
9