Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact D
(1-800-433-9258).
Replacement Accessories
Replacing spool Assembly (Fig. A, M, n)
1. Rotate the spool housing
spindle plate aligns with notch
housing. Insert a screwdriver through the notch and into
the hole, to prevent the spindle from turning.
2. Unscrew and remove the spool housing by turning the
spool head
16
clockwise.
nOTE: Do not try to remove the spool housing by
turning the spool cap
Fig. M
19
18
16
17
3. Remove spindle plate
housing. Remove any dirt and grass from the motor
housing and spindle plate.
4. Install spindle plate
20
double D shaped retaining nut
inside the base of the spindle plate.
5. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new
spool housing counterclockwise. Securely tighten the
new spool housing onto the spindle
10
WALT, call 1-800-4-D
WALT
e
e
until the hole
in the
8
18
in the motor
19
17
.
20
before installing a new
onto the spindle
, so the
21
on the spindle sits
22
21
.
Fig. N
22
Replacing Guard (Fig. O, P)
An extended coverage guard is available (sold separately)
for extra coverage if desired. Use D
guard Part Number 90624357.
WARNING:
without guard firmly in place. Damage or personal
injury could result.
1. Remove the spool housing as described in the
"Replacing Spool Housing" section.
2. Remove the 4 guard screws (
21
3. Lift the guard off at an angle as shown in figure P.
4. To attached a new guard, slide the tab (
guard under the lip (
lower the back of the guard into place as shown in
figure Q.
5. Replace and securely tighten the 4 guard screws (
6. Replace the spool housing as described in the
"Replacing Spool Housing" section.
WALT replacement
e
Never operate appliance
34
) shown in figure O.
fig. O
34
34
fig. P
36
) of the motor housing (
21
20
35
) of the new
6
) , then
34
) .
Publicité
Table des Matières
