Pioneer DVD-D302 Mode D'emploi page 6

A HARDWARE TOUR
1 2
1 SCSI ID switch
Used to specify the SCSI ID to be assigned to the DVD-D302 drive. When the drive
is to be used on the same SCSI bus as other devices (i.e., when the drive is to be
daisy-chained to other devices), different IDs must be assigned to all devices on the
same SCSI bus.
2 Audio output jack
Miniature jack used for analog audio output.
3 SCSI ports
4 SCSI termination switch
When components are connected through the SCSI connection, the terminator should
be attached to the last component in the connection. In case this drive is the last
component, set this switch to the on position.
5 Data block size switch
Used to specify the data block size. Set either to 512 bytes (OFF) or 2048 bytes
(ON).
6
<DRC1135>
En
3
DVD-ROM DRIVE
(when attached to changer)
4 5