tau D705M Notice D'installation page 13

WARNINGS
This manual has been especially written for use by qualified fitters. No information given in this
manual can be considered as being of interest to end users. This manual is attached to the
D705M control unit mounted on the MASTER20Q gearmotor, therefore it may not be used for
different products!
Important information:
Disconnect the panel from the power supply before opening it.
The D705M control unit has been designed to control an electromechanical gear motor for au-
tomating gates and doors of all kinds.
Any other use is considered improper and is consequently forbidden by current laws.
Please note that the automation system you are going to install is classifi ed as "machine con-
struction" and therefore is included in the application of European directive 2006/42/EC (Ma-
chinery Directive).
This directive includes the following prescriptions:
- Only trained and qualified personnel should install the equipment;
- the installer must first make a "risk analysis" of the machine;
- the equipment must be installed in a correct and workmanlike manner in compliance with all
the standards concerned;
- after installation, the machine owner must be given the "declaration of conformity".
This product may only be installed and serviced by qualified personnel in compliance with cur-
rent, laws, regulations and directives.
When designing its products, TAU observes all applicable standards (please see the attached
declaration of conformity) but it is of paramount importance that installers strictly observe the
same standards when installing the system.
Unqualified personnel or those who are unaware of the standards applicable to the "automatic
gates and doors" category may not install systems under any circumstances.
Whoever ignores such standards shall be held responsible for any damage caused by
the system!
Do not install the unit before you have read all the instructions.
Installation
This product must be correctly installed by a qualified fitter. The maker declines all liability for
damage caused by incapacity or neglect.
In particular:
1. make sure the cross-section of the power cables (power input, motors, earth and flashing
light) is at least 1.5 mm² and, in any case, sufficient for the absorption and length of the
wires. The above also applies to the other cables used by control and auxiliary devices ex-
cept that the minimum cross-section is reduced to 0.5 mm²;
2. make connections to the terminal board so as not to alter the level of protection offered by
the container which must be installed in a dry and protected place;
3. keep the power circuits separate from the control and auxiliary circuits, especially if the ca-
bles are long;
4. short any unused Normally Closed contacts.
The product must be properly earthed and the safety regulations in force in the
country of installation must be observed.
D705M 13