EIBENSTOCK ESM 1310 Notice Originale page 17

Attention!
!
In case of every stop of the machine, the lock button (2) has
to be released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
Rated speeds
Setting
A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster.
Functioning of the Electronics
1. Soft start
2. Constant speed in case of increasing working pressure
3. In case of overloading the motor, the speed is reduced until the user of
the machine again decreases the working pressure.
4. By means of a thermal sensor, in case of continuous overload, the
motor is protected against destruction. In fact, the machine switches
off automatically and only can be switched on again after a certain
cooling period (about 2 minutes). Press the on/off switch. The cooling
period depends on the heating of motor winding and ambient
temperature.
The ESM 1310 is equipped with an adjusting
wheel in order to allow a continuously variable
control of the speed from 1300 and 3050 rpm.
The adjusting wheel is on the top side of the
handle opposite of the on/off switch.
A
B
C
D
E
F
G
Speed (rpm)
1300
1600
1900
2200
2500
2800
3050
17