Publicité
Les langues disponibles
Les langues disponibles
vibrations occur or if other defects are recognised, switch off
immediately.
In case of using grinding tools with internal thread, make sure that the
internal thread is long enough to receipt the whole spindle thread
length.
Make sure that while grinding no sparks can pose a danger for persons
or ignite inflammable substances.
While working, lead the line cord or extension cord to the back away
from the tool.
Electric tools have to be inspected by a specialist in regular intervals.
Never carry the tool at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
When working with this tool, wear ear protectors, dust mask and
goggles.
Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
Always hold the tool with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The machine is equipped with a soft start which prevents that swift
automatic circuit breakers are unintentionally triggered.
Before connecting the machine with the mains supply, make sure that
it is switched off.
Switching on and off
Short-Time Operation
Switching-on:
press on/off switch (1)
Switching-off:
release on/off switch (1)
Permanent Operation
Switching-on:
press the on/off switch (1) and, keeping it pressed, engage
the lock button (2)
Switching-off:
press the on/off switch (1) and let it go off again
Electrical Connection
16
Publicité
