EIBENSTOCK ESM 1310 Notice Originale page 15

Application for Indented Purpose
The calender ESM 1310 is indented for professional use and suitable for
rough and fine grinding, as well as for mirror finish. According to the
accessories, surfaces of metal, plastic and wood can be finished, i. e.
sanded, deburred, burnished, structured, matted, calendered and polished.
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction and the safety instructions
completely and follow the instructions contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training. Save all
warnings and instructions for future reference.
If the connection cable gets damaged or cut during the
use, do not touch it, but instantly pull the plug out of the
socket. Never use the tool with a damaged connection
cable.
The tool must neither be wet nor used in humid
environment.
Do not use the tool near explosive materials (petrol, dilution).
Do not work with materials containing asbestos.
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is off.
When the machine runs outside, always use a protection switch (30 mA
max.) against fault current.
The machine should only work under supervision of somebody. Plug
and switch the machine off if it is not under supervision, e. g. in case of
putting up and stripping down the machine, in case of setting up and
striking, voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Do not use the machine if one part of the housing is damaged or in
case of damages on the switch, cable or plug.
Pay attention that the speed indicated on any disc or tool meets or is
higher than the max. speed indicated on the machine.
Grinding wheels have to be stored and used carefully and following the
instructions of the producer.
Check the accessories before use. Do not use any products which are
broken away, cracked or damaged in another way.
Before use, make sure that the tool is correctly fixed and fastened. Let
it run idle for about 30 seconds in a safe position. If considerable
15