Grease Filters - ETNA AOP380 Série Mode D'emploi

MAINTENANCE

Grease filters

Clean the grease filters at least once a month. Cleaning will result in the aluminium parts of
the filters becoming dull due to the use of cleaning agents, in particular when cleaned in a
dishwasher. This is normal, and is not covered by the warranty.
Removing the grease filters
Before you can remove the grease filters, you must open the edgeextractor panel (magnetic
closure).
1. Switch off the cooker hood.
2. Hook your fingers behind the panel and use your thumbs to lever it away from the edge of
the extractor hood.
3. Flip the edge-extractor panel downwards.
4. Pull the handle of the grease filter towards you and tilt the front downwards.
5. Clean the grease filters.
6. Put the filter back into place by first pushing the rear side into the holder. Tilt the front side
upwards. The filter is now once again in place.
7. Press the edge-extractor panel into place.
EN 8