Maintenance; Cleaning - ETNA AOP380 Série Mode D'emploi

MAINTENANCE

Cleaning

Note!
Before carrying out maintenance work, always disconnect the cooker
hood from the power supply by setting the group fuse in the meter
cupboard to '0' or removing the fuse. If present, the cooker hood can
also be disconnected from the power supply with the On / Off switch
located at the top of the cooker hood.
The inside and outside of the cooker hood must be cleaned at regular
intervals. Do not use abrasive products. Do not clean with alcohol!
Note!
Failure to follow these instructions for cleaning the appliance and
replacing the filters can result in fire. Always follow these instructions!
The manufacturer is not liable for damage to the hood or damage
caused by fire that is due to inexpert maintenance or the failure to
follow the aforementioned recommendations and the safety instructions
supplied with the appliance.
Clean the cooker hood with a soft cloth with water and a little
detergent. Then wipe with clean water. Do not use corrosive cleaning
agents such as soda, and do not use scouring sponges or similar. Treat
with a product designed for the maintenance of stainless steel and
polish in the direction of the surface finish of the stainless steel.
Metal grease filters
Metal filters must be cleaned once per month (or when the filter
cleaning indicator – if present on the model – indicates that this is
necessary). Clean the filters with neutral cleaning agents, by hand or in
the dishwasher at low temperatures and with a short programme. Put
the grease filters in the dishwasher with the openings facing down so
that the water can drain. Aluminium grease filters will become dull from
the cleaning agents in the dishwasher. This is normal, and does not
affect the performance.
The saturation of the filter depends on the intensity of use, the manner
of cooking and the regularity with which the grease filters are cleaned.
EN 7