Settings On The Saw; Working With The Saw - ATIKA BSV 315 Notice Originale

Connect splinter extraction
In closed rooms work only with a splinter extraction
(air speeds at suction socket of the saw ≥ 20 m/sec.).
Sawing without splinter extraction only
for short-time service (up to 30 min.)
or with a protective mask
or open-air
If you do not connect splinter extractor sawdust will con-
centrate which you have to remove regularly.
Connect sawdust extraction system or small dust extractor
with a suitable adapter to the sawdust suction socket.

Settings on the saw

17
Saw band tension
A too high stress can result in the break of the saw band.
A too less stress can result in the drive wheel sliding
through and then result in the stop of the saw band.
You can check the stress:
Put the upper saw band coping (19) completely upwards (see
„Adjustment of the upper saw coping) and press with the finger
in the middle between the saw table and the upper saw coping
transversally against the saw band
it shall only be possible to push the saw band in laterally by
3 – 5 mm.
18
With the adjusting wheel (1) the stress of the saw band can be
corrected.
Increase stress (+)
turn adjusting wheel clockwise
Reduce stress (-)
turn the adjusting wheel anti-clockwise
19
Incline of the upper band saw roll
With the adjusting wheel (25) the incline of the upper band saw
roll (17) can be changed. The adjusting causes that the saw
band runs in the centre of the band saw roll.
Before adjusting release the fixation screw nut (G).
Saw band runs backwards
turn the adjusting wheel clockwise
Saw band runs forwards
turn the adjusting wheel anti-clockwise
After adjusting refasten the fixation screw nut (G).
20
Transverse adjustment of saw table
Release fixation screw (D).
The saw table can continuously be inclined against the
saw band up to 45°.
21
Parallel stopper
The parallel stopper (14) is clamped on the saw table. It
can be assembled on the right or on the left of the saw
band.
Mount the stopper ruler on the side of the stopper guid-
ance which faces towards the saw band.
22
Adjust cutting speed
1. Open lower case door.
2. Loosen drive belt by turning the crank (11) clockwise.
3. Put drive belt on the corresponding belt pulley at the drive
wheel (lower band saw roll) and on the corresponding en-
gine belt pulley.
The adjustments are indicated in the following plan which is
also fixed on the inside of the case door.
Material Cutting speed
Hardwood
370 m/min
Plastics
NF-Metals
Wood 800 m/min
Never put on the drive belt transversally. It must run
either on both front or both back belt pulleys.
4. Clamp again the drive belt by turning the crank (11) anti-
clockwise.
The drive belt shall be able to be bended in the middle
app. 10 mm.
5. Close lower case door.
6. Keep saw running at least one minute for testing.
7. Switch off the saw and pull out the power plug. Check then
the position and the tension of the drive belt and correct it if
necessary.

Working with the saw

Before starting to work consider the following safety ad-
vices to keep the risk of injuries as small as possible.
Saw band o.k.?
Parallel stopper ready to use?
Pushing stick ready to hand?
1
2
18