Publicité
8
English
TO REMOVE/REPLACE SHIELD ( XC )
To remove the shield, first place it in the fully open position. When the
shield is in its fully open position, levers appear under the shield holding
arms. With your thumb or a rod like a ballpoint pen push these levers
straight forward in the arrowed direction until they stop (about 5mm,
1/8"), which releases the locking system. Then, raise the shield further to
remove shield assembly from helmet.
NOTE:
The shield cannot be removed from any other position as the locking
system will be engaged.
To replace shield, place each shield holding arm onto base plate on each
side so that the lower edge of the arm on each side lines up with the guide
line marked on each base plate.
NOTE:
The shield can only be replaced at its remove/replace position. Check
its angle as you remove the shield and duplicate it to replace the shield.
Publicité
Chapitres
