Preventing Equipment From Falling Over; Fixing The Rotation To The Front - Pioneer PDK-TS05 Mode D'emploi

Preventing Equipment from Falling Over

After installing the stand, be sure to take measures so that the equipment will not fall over.
Stabilizing on the floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on the
floor use screws that have a
nominal diameter of 6 mm (1/4
inch) and that are at least 20 mm
(13/16 inch) long.
Position of floor screws: Without speakers
Unit: mm (inch)
120
575 (22-21/32)*
(4-23/32)
500 (19-11/16)**
* : 50 inch display model
** : 43 inch display model
Using a wall for stabilization
(43 inch display model in the figure)
1
2
Min. 20 mm
(13/16 inch)
Note
Use hooks, ropes, chains, and fittings
that are available on the market.
Recommended hook:
Nominal diameter 8 mm (3/8 inch)
Length 12 to 15 mm (1/2 to 5/8 inch)
2
575 (22-21/32)*
500 (19-11/16)**
Fitting

Fixing the rotation to the front

Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
Use a screw that has a nominal
diameter of 4 mm (3/16 inch)
and length from 15 to 20 mm
(5/8 to 13/16 inch) to fix the
rotation to the front.
Attaching falling prevention bolts (hooks)
to the plasma display.
Using strong cords or chains to firmly
stabilize it to a wall, pillar, or other sturdy
element.
Perform this work in the same way on the left and
right sides.
The length of the cords or chains used must be long
enough to allow the stand to rotate freely.
1
Hook
Cord or chain
12 to 15mm
(1/2 to 5/8 inch)
15 to 20 mm
(5/8 to 13/16 inch)
21
En