Using Your Appliance:
SELECTING A WASH PROGRAM:
1) Press and hold the "START/PAUSE" button for approximately 3 seconds to turn on your machine. (Noted
that the door of the dishwasher must be in the OPEN position to access the control panel.)
2) Refer to the Pre-Programmed Wash Cycles table on the previous page, to select a wash program suitable
for your needs.
3) Press the "PROGRAM SELECTION" button until the number of the program you selected appears in the
display.
4) Press the "START / PAUSE" button and close the door of your appliance within approximately 4 seconds
to activate the wash program.
If the door is not closed within approximately 4 seconds, the unit will not start the wash program.
In this case, you must open the door press the "START/PAUSE" button again and close the door within 4
seconds to activate the wash program.
CANCELLING A WASH PROGRAM:
1) Press and hold the "PROGRAM SELECTION" button for approximately 3 seconds.
2) The display will show "1" to confirm cancellation of the wash program.
Note:
If the door is opened during a wash cycle, the door must be closed within 4 seconds to continue the
current wash cycle.
If the door is not closed during the 4 seconds, simply press the "START/PAUSE" button again and close the
door within 4 seconds to activate the wash program.
SELECTING AN OPTIONAL WASH OPTION:
1) Select the desired Pre-Programmed Wash Program as directed above.
2) Before pressing the "START/PAUSE" BUTTON, press the "OPTIONS" button.
3) Continue to press until the indicator light of the option you desire is illuminated.
Note: In order to select the "HALF LOAD" option, press and hold the "OPTIONS" button for approximately
3 sections.
4) Press the "START / PAUSE" button and close the door of your appliance within approximately 4 seconds
to activate the wash program.
5) If the door is not closed within approximately 4 seconds, the unit will not start the wash program.
6) In this case, you must open the door press the "START/PAUSE" button again and close the door within 4
seconds to activate the wash program.
Wash Options:
HALF LOAD:
This option allows you to save energy and wash a smaller load. This option should be used when washing
less than a full load or in the event you do not want to load the washer and run later when completely loaded.
SANITIZE:
When the Sanitize option is selected, the water temperature will be maintained at 156ºF/69ºC (maximum). The
maximum temperature may not be reached if the incoming water temperature is not adequate.
Residential dishwashers are not intended for licensed food establishments or Commercial applications.
HI-TEMP:
When the HI-Temp option is selected, the water temperature will be maintained at 140ºF/60ºC (maximum).
The maximum temperature may not be reached if the incoming water temperature is not adequate.
Residential dishwashers are not intended for licensed food establishments or Commercial applications.
8