How To Efficiently Load Your Dishwasher - Avanti DWT18V3S Manuel D'instructions

Adjusting Rinse Aid Dispenser
A measured amount of rinse aid is released during the final rinse. As with detergent, the amount of rinse aid
needed for your dishes depends on the hardness of the water in your area. Too much rinse aid can result in
lather of foaming and cause cloudiness or streaks on your dishes. If the water in your area is very soft, you may
not need rinse aid. If you do, you can dilute the rinse aid with an equal amount of water.
When To Refill The Rinse Aid Dispenser
Refill the Rinse Aid reservoir when the Rinse Aid indicator light on the control panel is illuminated.
How to load your dishwasher
For best results, follow these loading guidelines.
Recommendations : Remove any coarse residue on dishes before placing the dishes in the machine. Start the
machine with full load.
Do not overload the drawers or place dishes in the wrong basket.
WARNING: Always place sharp utensils with the sharp point down and open utensils with their openings down.
How to Use the Upper Rack
The upper rack is designed to hold more delicate and lighter dishware such as glasses, coffee and teacups and
saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). Position the dishes and
cookware so that they do not get moved by the spray of water.
The upper rack can be adjusted for height by putting wheels at different height into the rails.
Caution: Make sure that the rack is empty. Changing the height setting while the rack contains tableware could
cause the contents to dislodge, causing personal injury or damage to the tableware.
1) Release the latches on both the right and left tracks of the upper rack by turning them toward the outside
(illustration A).
2) Pull out the rack completely. (illustration B).
3) Place the rack into the track again at the desired height (illustration C).
4) Push the latches back into the correct position.
How To Use The Lower Rack
We recommend that you place large items which are most difficult to clean into the lower rack: pots, pans, lids,
serving dishes and bowls, as shown in the figure below.
It is preferable to place serving dishes and lids on the side of the racks in order to avoid blocking the rotation of the
top spray arm.
Pots, serving bowls, etc, must always be placed top down. Deep pots should be slanted to allow water to flow out.
The bottom rack features fold down tine rows so that larger or more pots and pans can be loaded.
11