Texecom Premier Elite Série Guide De L'utilisateur page 5

To RESET After an Alarm
If the display shows 'SYSTEM ALERTS', follow the steps described in 'To DISPLAY the causes of System Alerts' above, before
attempting to reset.
USER Reset
Once the alarm has been silenced (see page 7 for details), the system will need to be reset.

If the system has been programmed, to be reset by an Engineer, pressing
details. The system may have been programmed to be reset by Anti-code, if this is the case, see ANTI-CODE Reset for details.
1. Enter a valid User code

2. Press The external strobe will stop, the system will chime and the display will return to normal.
ENGINEER Reset
If the system has been programmed to be reset by an Engineer following an alarm activation, you will still be able to silence the alarm
by entering a valid User code (see page 7 for details).

The system cannot be armed again until the alarm has been reset.
Contact the telephone number on the display (if programmed) or the telephone number on the last page of this User Guide
ANTI-CODE Reset
If the system has been programmed to be reset using an Anti-Code following an alarm activation, you will still be able to silence the
alarm by entering a valid User code (see page 7 for details).

The system cannot be armed again until the alarm has been reset.
1. Enter a valid User code

2. Press The display will show a random code number i.e. 4281.
3. Contact the telephone number on the display (if programmed) or the telephone number on the last page of this User Guide
and quote the random code number You will be given a 4-digit Anti-Code i.e. 5624.
4. Enter the Anti-code that has been given to you

5. Press If the Anti-code is correct, the keypad will bleep to indicate that the system has been reset and the display will
return to normal.
To OMIT Zones
It is possible to exclude (omit) individual zones when arming i.e. if a zone is 'in fault'. Users with access to this function can only omit zones that
have been programmed as 'Omittable'.

If the zone can be omitted, there will be a 'Star' to the right of the zone number. Only zones that have the 'Omit' attribute assigned to them can be omitted. A
'Star' will appear to the left of the zone number to indicate that the zone has been selected for omitting. All omitted zones will be automatically reinstated the next
time the system is disarmed, unless programmed otherwise. To re-instate zones manually, simply follow the instructions again. However, when the
is pressed on this occasion, the zones will be re-instated.
1. Enter a valid User code
2. Enter the zone number

3. Press to omit the selected zone Repeat for other zones if required.

4. Press when finished Continue to arm the system as normal.
The Turn CHIME On and Off
The system can be set up so that activating (opening) certain zones will cause the internal sounders to chime. This would normally be
used on a front door, exit button etc.

Zones will only cause the internal sounders to chime if they are selected for chime (see Master User Guide for details on selecting which zones chime).
Once a zone has been selected for chime, the Chime facility can be manually turned on and off as required.

The system can also be programmed to automatically turn chime on and off under certain conditions i.e. certain times of the day, door left open etc. If no
zones have been programmed for Chime, then turning Chime on and off will have no effect.
To turn CHIME On
1. Press
The Chime tone will sound.
INS555-2






will not return the display to normal, if this is the case see ENGINEER Reset for


and press
The Error tone will sound.
Premier Elite Series User Guide
To turn CHIME Off

1. Press
key

5