Samson Go Mic Mobile Guide Rapide page 15

Owner's Manual
Mounting to a tablet
1. Completely loosen and remove the Lock Screw.
2. Slide and remove the Adjustable Mounting Arm.
3. Slide the Insert Cover into the receiver and tighten the Lock Screw
4. Remove the fixed Mounting Arm by removing the two Phillips head screws.
5. Affix the Large Hook-and-loop piece by peeling the adhesive backing off of the
hook side and placing the Large Hook-and-loop section onto the back of the Go
Mic Mobile Receiver.
6. Remove the backing of the loop side and position the receiver on the rear side of
the tablet.
7. Press the Go Mic Mobile Receiver against the tablet to secure.
8. If the Go Mic Mobile Receiver is not secure, use the additional Small Hook-and-
loop section..