"Delay Start" Button - Candy CDI 5550 P Mode D'emploi

"DELAY START" button

Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
Press the "DELAY START" button ("00"
will appear on the display).
Press the button again to increase the
delay in hours (each time the button is
pressed the delay is increased by 1 hour
to a maximum of 23).
To start the countdown press the "START"
button. At the end of the countdown, the
programme will automatically start.
If you wish to see which programme has
been selected, press the "PROGRAMME
SELECTION" button.
Proceed as follows to cancel a delayed
start:
Hold the "START" button down for at
least 5 seconds.
At this point, a new programme and
option buttons must be set to start a
new programme as indicated in the
"PROGRAMME SETTINGS" section.
Alarm mute for the PROGRAMME
END
The alarm for the programme end may be
muted as follows:
With the dishwasher off, hold down the
"PROGRAMME SELECTION" button
for few seconds while simultaneously
pushing the "ON/OFF" button.
"b1" will appear on the display to indicate
that the alarm is on.
Press the "PROGRAMME SELECTION"
button again "b0" will appear on the
display to indicate that the alarm is off).
Wait for the alarm to sound to indicate
that the settings were saved.
To turn the alarm on again, follow the
same procedure ("b1" will appear on the
display to indicate that the buzzer is on).
WARNING!
To ensure the correct operation of
the anti-overflow safety device, we
recommend that the dishwasher is
not moved or tilted during operation.
If however it is necessary to tilt or
move the dishwasher, please ensure
that the washing cycle is complete
and that there is no remaining water
inside the dishwasher.
16
The dishwasher is able to signal a series of faults in the display.
AUTOMATIC FAULT SIGNALS
FAULTS
E2 No water (inlet hose closed).
appears on the display and
the alarm sounds.
E3 The machine cannot drain water.
appears on the display and
the alarm sounds.
E4 Water leak
appears on the display and
the alarm sounds.
E5 Electronic temperature control fault.
appears on the display and
the alarm sounds.
E6 Electronic control fault.
appears on the display and
the alarm sounds.
E8 Ei The water heating element is not
or appear on the display
working correctly or the filter plate is
and the alarm sounds.
clogged.
CAUSE SOLUTION
Turn off the dishwasher, open the
inlet hose and reset the cycle.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Contact Customer Service.
Contact Customer Service.
Clean the filter plate.
If the problem persists, contact
Customer Service.
17