ThermoKey Wet Fin Systems Manuel Technique page 6

ThermoKey Heat Exchange Solutions
TC 3. Preliminary Remarks
ThermoKey equipment needs to be properly installed, operated and maintained.
Documentation of the equipment used, including drawing, technical data sheet and the present manual should be kept on
record: ThermoKey recommends to study this manual carefully and, importantly, to make it available for the personnel
who installs, operates and maintains the equipment.
In order to achieve a long, trouble-free and safe operation, it is necessary to establish an operating plan including a
schedule of regular inspection, monitoring and maintenance. All inspections, maintenance and monitoring actions should
be recorded in a cooling system logbook. Operating and maintenance instructions published here can be used as a guide
to achieve these goals.
In the unlikely case that you may have some problem not contemplated in this manual or that some information is not
completely clear, don't hesitate to contact ThermoKey. Please make sure in advance, that you have checked the Installation
and Maintenance Manual of the remote air-cooled unit.
ThermoKey will not be in any way responsible and the product warranty will no longer be valid if these instructions are
not observed or the units are not used correctly.
TC 3.1 AUTHORIZED PERSONNEL
Operation, maintenance and repair of this equipment should be undertaken only by authorized and qualified personnel.
All such personnel should be thoroughly familiar with the equipment, associated systems and controls and the procedures
set herein and in other relevant manuals. Proper care, procedures and tools must be used in handling, lifting, installing,
operating and repairing of this equipment to prevent personal injury and/or property damage.
TC 3.2 MECHANICAL SAFETY
Mechanical safety of the equipment is in accordance with the requirements of the EU machinery directive.
§ §
Don't walk or place heavy on the ramps,racks, pipelines.
§ §
Also read the Installation and Maintenance Manual of the remote air-cooled unit on which the adiabatic system is installed.
§ §
TC 3.3 ELECTRICAL SAFETY
No service work should be performed on or near the fans, unless motors are electrically isolated.
§ §
Before proceeding with electrical maintenance on a fan, make sure that repair switch is open and padlocked.
§ §
Before proceeding with electrical wiring, make sure that power line circuit is open and Box main switch is open and
§ §
padlocked.
TC 3.4 LOCAL REGULATIONS
Installation and operation to cooling equipment may be subject to local regulations, such as establishment of risk
§ §
analysis. Ensure regulatory requirements are consistently met.
TC 3.5 NOTES
The manufacturer reserves the right to make any modifications it deems necessary to the manual at any time.
§ §
The total or partial reproduction of this manual is strictly prohibited without the manufacturer's written authorization.
§ §
For the Conditions of Guarantee, refer to the conditions specified in the order confirmation. Any kind of intervention
§ §
must be agreed in advance with ThermoKey Spa. Failure to do so will render the Conditions of Guarantee null and void.
09 MT TC R WFS EN 03 2018
For any other information please examine the Installation and Maintenance Manual of the remote air-cooled unit on
§ §
which the adiabatic system is installed.
ThermoKey is not responsible for all actions caused by not correct adopting of manual's instructions, that could induce
§ §
damages to persons.
TC 3.6 HYGIENE CERTIFICATE
Mainzoniversitätsmedizin Laboratory certifies that the WFS meets the standard VDI 2047 part 2 securing hygenically
§ §
sound operation.
MT TC R WFS EN 03 2018
Technical Manual TC Instruction and technical data
10