ThermoKey Wet Fin Systems Manuel Technique page 11

Table des Matières

Les langues disponibles

ThermoKey

Heat Exchange Solutions

TC 10.4 OPERATING PROBLEMS

PROBLEM

Water is not reaching the nozzles

SOLUTION

Ensure that the inlet valve is fully opened

Ensure that the pressure and flow rate values are correct

PROBLEM

The water reaching the nozzles is not sufficient

Ensure that the inlet valve is fully opened

SOLUTION

Ensure that the pressure and flow rate values are correct

Some areas of the finned pack are not being sufficiently covered by the spray jet

PROBLEM

SOLUTION

Ensure that the pressure and flow rate values are correct

Check for the presence of foreign bodies inside the nozzles and clean them

Check if nozzles are right oriented in air direction

PROBLEM

Excessive accumulation of water inside the remote unit

SOLUTION

Check that the torque of all screws of pipe

Check for the presence of foreign bodies inside the nozzles and clean them

Ensure that the pressure and flow rate values are correct

TC 11. Spare Parts

NOZZLES (U00) - M250531

Tangential flow hollow cone+2 gaskets + Baionet collar + 2 inox screws

Materials: Plastic material (POM nozzles + Polyamid collars))

Range: 0,5 bar @ 0,20lt/min ▶ 5 bar @ 0,63lt/min

NOZZLES (U05) - M250513

Tangential flow hollow cone+2 gaskets + Baionet collar + 2 inox screws

Materials: Plastic material (POM nozzles + Polyamid collars))

Range: 0,5 bar @ 0,31lt/min ▶ 5 bar @ 1,00lt/min

INLET 1/2" MAGNETIC ELECTRO-VALVES (MV4=MV5) - M1906386

Type 1132/04S + 9 - 150/R02(HM2): 1/2" Female Gas Inlets

24V -50/60HZ-A.C.-IP65