Emergency Release; Lubrication - Cembre SD-15PR-ECO Notice D'utilisation Et Entretien

at this stage, release the accelerator (08) and the return springs (25) will automatically retract
the machine.
NOTE: if the auger is blocked in the wood, set the left sense of rotation
machine to disengage the auger.

4.3) Emergency release

Correct operation of the machine and its safe and rapid release of the augers,
in case of need, are guaranteed only by using Cembre original PV range.
augers.
To remove the machine during a drilling operation, proceed as follows:
– Immediately release the accelerator.
– Operate the emergency lever (12) moving it downwards.
– Keeping the lever depressed, slightly twist the machine, to release the auger. Lift and remove
the machine from the auger.
5. MAINTENANCE
Before servicing or removing any parts, stop the engine and allow it to cool.
Always remove the spark plug cap from the spark plug when servicing the
engine to prevent accidental starting.
Periodic inspections are essential for the proper functioning of the engine;
refer to "KAWASAKI" manual provided with the machine for the safe use of
the engine and for further requested maintenance operations.
5.1) Routine maintenance of the machine

5.1.1) Lubrication

(Depending on ambient conditions and use) periodically lubricate the return spring shafts,
proceeding as follows:
– Remove two guard knobs (22).
– Remove the detachable guard (21) and the springs (25).
– Carefully wipe the shafts (24) using a clean cloth wetted with kerosene.
– Lubricate the shafts with a general purpose oil.
– Re-assemble the springs, detachable guard and the two guard knobs (22).
9
ENGLISH
and operate the