Setting The Rotation Direction - Cembre SD-15PR-ECO Notice D'utilisation Et Entretien

ENGLISH

4.1.4) Setting the rotation direction

The rotation direction of the spindle is set using the 3 position
selector (33):
: right sense of rotation, for drilling.
: idle position (main shaft gears disengaged).
: left sense of rotation, to allow the auger to be
disengaged when blocked in the wood.
WARNING: adjustment of selector (33) must always be carried out with the engine switched
off or idling to ensure correct engagement of gears.
4.2) Using the drilling machine
The drilling machine can be used independently or in conjunction with the support trolley:
4.2.1) Using the drilling machine "independently" (Ref. to Fig. 5)
Make sure the rotation direction selector (33) is in position "N" (idle position).
With the drilling machine on the ground, follow the instructions in § 7.
Allow the machine to "warm up" for 2 minutes prior to commencement of work.
Locate the machine on the sleeper in the desired position, locate the guard end piece (33) into
the bush of the chair and proceed as § 4.2.3.
4.2.2) Using the drilling machine with the support trolley (Ref. to Fig. 6).
– Insert the spigot (30) of the drill into the housing of the trolley (see Fig. 3).
With the drilling machine supported by the trolley, proceed to move the main handle through
90° as follows:
– Loosen the screw and release the main handle (06) from the drill (1) (see Fig. 3 and 4).
– Place the main handle (06) in the new position (2) (see Fig. 4) insert the locating pins, through
the slot, into their corresponding holes.
– Tighten the screw with spanner 10 mm.
– Make sure the rotation direction selector (33) is in position "N" (idle position).
– Follow the instructions in § 6 and allow the machine to "warm up" for 2 minutes prior to
commencement of work.
– Using the main handle on the drilling machine, move the trolley over the sleeper to the desired
hole position and locate the guard end piece, in the bush of the chair.
Note: For use of the support trolley, refer to specifi c "Operation and Maintenance Manual".
4.2.3) Drilling
With the engine at minimum revs, set the right sense of rotation
The auger starts to rotate only when the engine is fully revved: rev the engine gradually and
then apply a slight starting pressure on the machine, so that the bit tip catches and starts drilling
the wood with automatic advancement, without additional force from the operator. When the
preset drilling depth is reached, the adjustment device (26) prevents any further advancement;
Reference
33
(see § 4.1.4).
8