Teac NP-H750 Mode D'emploi page 13

F
AUX 1 IN/OUT jacks
These input/output analog audio signals.
Connect this unit's input and output jacks to the output
and input jacks of other devices using commercially
available audio cables.
p Connect an audio cable's white pin plug to the
white (L) jack and connect its red pin plug to the
red (R) jack.
White (L)
Red (R)
p If you want to use a recorder (eg. a cassette deck or
a CD recorder) with this unit, connect the output
jacks of the recorder to the AUX 1 IN jacks of this
unit and connect its input jacks to the AUX 1 OUT
jacks.
p Be sure to insert each plug securely. To prevent hum-
ming and interference, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
G
PHONO jacks
Connect the turntable's RCA pin cable to the PHONO
jacks.
p Connect an audio cable's white pin plug to the
white (L) jack and connect its red pin plug to the
red (R) jack.
p Be sure to insert each plug securely. To prevent hum-
ming and interference, avoid bundling the signal
White (L)
interconnection cables together with the AC power
Red (R)
cord or speaker cables.
p This unit supports the use of MM cartridges (input
sensitivity: 2.5 mV/47 kΩ). It does not support the
use of MC cartridges.
H
Grounding connector [SIGNAL GND]
Connect the grounding wire of the turntable here.
p This is not an electrical safety ground.
p If the grounding wire of the turntable is not con-
nected here, hum noise may be heard.
13 13