Amica PG4V 0 Série Mode D'emploi page 21

Installation in the furniture worktop PB*4V*0...
• Cut the opening in the furniture worktop according the dimensions indicated on the figure
(Fig. A).
• The minimum clearance under the hob is 80 mm.
• Connect the hob with a power cord according to the attached diagram.
• Select the power cord core cross-section to match to the hob power (this should be done
by an authorized installer).
• Check the hob gasket for any defects and correct fitting to the hob.
• Clean the worktop, place the hob in the opening and push into worktop opening.
Fig. A
PBF..., PBP...
1 2 3
21
1 - table top
2 - Hob
3 - ceramic plate