Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To work with this microscope, sharp and pointed aids are being used.
Please take care that this microscope and its accessories are stored at a
place out of reach of children. Let children only work with this microscope
Keep packing material (plastic bags etc.) away from children!
Scope of delivery: 2 Rubber eye cups, Power cable, Fuse, Dust cover, Manual.
1. Parts of the microscope
Eyepieces
B
Diopter adjustment ring
C
Objective
D
Front microscope arm
Microscope pole
F
Rear microscope arm
Locking ring
Microscope base
Connecting screw
J
Suitable location for observation:
Dry and dust free, room temperature between -5 and +40°C.
Position your device so that it can be disconnected from the power supply at any time.
The wall socket should always be located near the device and be easily accessible, since
the plug on the power cord serves as a disconnecting device for the power supply.
2. Assembly
I. Place the base (8) on a stable surface.
II. Attach the rear microscope arm (6) to the pole of the microscope base.
III. Use the locking ring (7) to secure the microscope arm.
IV. Connect the front part of the microscope arm (4) to the rear arm. Insert the connecting
screw (9) through the hole in the rear microscope arm. Take care that the flattened edge
shows backwards. Now attach the two washers and the front microscope arm to the
screw. Tighten the lock nut (10) with the lever until the front microscope arm does not
tilt down.
V. Connect the power cable to the power connector (13) of the microscope and a free
power outlet.
6
CAUTION!
under an adult's supervision!
Lock nut
Focusing wheel
Illumination
Power socket
Fuse holder
On/Off switch
WF 20x eyepieces (optional)
Rubber eye cups (2x)
Fuse (F2AL250V)
Publicité
Table des Matières
