Optional Accessories - Makita JV0600 Manuel D'instruction

secure it.
2. Circular cuts
When cutting circles or arcs of 170 mm (6-11/16")
or less in radius, install the rip fence as follows.
4
3
011972
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
1
011973
Now slide the rip fence to the desired cutting radius,
and tighten the bolt to secure it in place. Then move
the base all the way forward.
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
Anti-splintering device (Optional accessory)
1
011974
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
1. Threaded knob
2. Pin
3. Rip fence
(Guide rule)
4. Fence guide
1
2
1. Rip fence (Guide
rule)
1. Anti-splintering
device
2. Tool base
2
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.
Cover plate (Optional accessory)
011975
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Jig saw blades
•
Hex wrench 3
•
Rip fence (guide rule) set
•
Anti-splintering device
•
Hose (For vacuum cleaner)
•
Cover plate
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
8
1. Cover plate
1
2. Tool base
2
or attachments
Only use accessory or
are