Replacing Carbon Brushes; Optional Accessories - Makita XVJ03 Manuel D'instruction

1
007499
When cutting circles or arcs of 170 mm (6-11/16") or less
in radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
•
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting radius,
•
and tighten the bolt to secure it in place. Then
move the base all the way forward.
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1. Fence guide
2. Threaded knob
3. Circular guide
pin
2
3
1. Limit mark
1
1
007505
After replacing brushes, insert the battery cartridge into
the tool and break in brushes by running tool with no
load for about 1 minute. Then check the tool while
running and electric brake operation when releasing the
switch trigger. If electric brake is not working well, ask
your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Jig saw blades
•
Hex wrench 4
•
Rip fence (guide rule) set
•
Anti-splintering device
•
Cover plate
•
Dust nozzle
•
Makita genuine battery and charger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
10
1. Brush holder cap
2. Screwdriver
2
or attachments
Only use accessory or
are