Makita JV0600 Manuel D'instruction page 6

the fixed position by itself and the blade is locked. Pull
the blade lightly to make sure that the blade does not fall
off during operation.
CAUTION:
If the lever does not move to the fixed position by
•
itself, the blade is not installed completely. Do not
press the lever by hand to the fixed position. It may
damage the tool. Make sure that the back edge of
the blade fits into the roller.
To remove the blade, push the lever forward as far as it
will go. This allows the blade to be released.
Hex wrench storage
1
2
011960
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
Advance the tool very slowly when cutting curves or
•
scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
Hold the tool firmly with one hand on the main
•
handle when performing the tool. If necessary, the
front part of the tool may be supported by the other
hand.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed.
1
011961
Then rest the base flat on the workpiece and gently move
the tool forward along the previously marked cutting line.
1. Wrench holder
2. Hex wrench
1. Cutting line
2. Base
2
Bevel cutting
011962
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
011963
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
1
011964
Tilt the base until the desired bevel angle is obtained.
The edge of the housing indicates the bevel angle by
graduations. Then tighten the bolt to secure the base.
Front flush cuts
1
011965
6
1. Hex wrench
1
2. Bolt
3. Base
2
3
1. Edge
2
2. Graduation
1. Base
2 2. Hex wrench
3. Bolt
3