Fusion Signature Série Instructions D'installation page 4

Sports Model Front View
Dimension 6.5" Speakers 7.7" Speakers
176 mm (6.93 in.) 196 mm (7.69 in.)
156 mm (6.13 in.) 176 mm (6.94 in.)
Classic Model Back View
Dimension 6.5" Speakers
200 mm (7.88 in.)
156 mm (6.13 in.)
Cleaning the Speakers
NOTE: When mounted correctly, these speakers are rated IP65 for protection
in the harsh marine environment from the front of the speaker. They are not
designed to withstand high pressure water spray, which may occur when you
wash down your vessel. Failure to carefully spray-clean the vessel may
damage the product and void the warranty.
NOTICE
Do not use harsh or solvent-based cleaners on the speakers. Using such
cleaners may damage the product and void the warranty.
1
Clean all salt water and salt residue from the speaker grille with a damp
cloth soaked in fresh water.
2
Use a mild detergent to remove a heavy buildup of salt or stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you should perform
a few simple troubleshooting steps to help diagnose the problem.
If the FUSION speaker has been installed by a professional installation
company, you should contact the company so the technicians can assess the
problem and advise you about possible solutions.
There is no sound coming from the speakers
• Verify that all connections from the source device and/or the amplifier are
connected correctly to the speaker terminals.
4
8.8" Speakers
224 mm (8.8 in.)
202 mm (7.95 in.)
7.7" Speakers 8.8" Speakers
220 mm (8.69 in.) 247 mm (9.72 in.)
176 mm (6.94 in.) 202 mm (7.95 in.)
The system lacks bass or high frequencies
• Verify that the correct wire polarity is observed between the source and
speakers.
The wires should be connected positive to positive and negative to
negative.
• Verify that the speakers are attached firmly to the mounting surface.
The audio is distorted
• Verify that the source volume is not too loud for the speaker, and reduce
the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel are not
rattling.
• Verify that the source device and/or the amplifier are connected to the
speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the input level of the
amplifier is matched to the output level of the stereo. For more information,
see the manual for the amplifier.
The LED lights will not turn on
• Verify that all wiring connections are correct and tight.
The LEDs pulse with the bass notes of the music
• Install a FUSION LED voltage regulator (SG-VREGLED).
Specifications
Specification 6.5" Speakers
Max. power (Watts) 230 W
RMS power (Watts) 75 W
Efficiency (1 W/1 m) 90 dB
Frequency response 70 Hz to 22 kHz
(+ 3 dB)
Min. mounting depth 79 mm (3.11 in.) 86 mm (3.39 in.) 105.5 mm (4.15 in.)
(clearance)
Mounting diameter 136 mm (5.35 in.) 156 mm (6.12 in.) 188 mm (7.4 in.)
(clearance)
Impedance 4 ohms
LED Supply Voltage From 10.8 to 16 Vdc
(Sports Model Speakers
only)
LED Load Current at 150 mA
14.4 Vdc (Sports Model
Speakers only)
Operating temperature From 0 to 50°C (from 32 to 122°F)
range
Storage temperature range From -20 to 70°C (from -4 to 158°F)
Tweeter type Silk dome
Compass-Safe Distances
All speakers contain magnets which may cause interference with instruments
on your boat. The size of the magnet used in the speaker affects how much
interference the speaker may cause.
Interference can cause deviations and variations in the readings of sensitive
navigational equipment, such as magnetic compasses. These deviations can
cause inaccuracies or offsets in the readings, but will not harm the equipment.
To alleviate the deviations, adjust the compass for the deviation following the
manufacturer's instructions or move the speaker away from the navigational
equipment. After moving a source of interference, you may need to recalibrate
the compass.
If you are navigating solely by a magnetic compass, use extreme caution to
place the speaker far enough away from the compass to avoid causing
deviations in the readings.
To avoid deviations to navigational equipment, position the speakers so they
are separated from the navigational equipment by at least the distance listed in
the table below.
7.7" Speakers 8.8" Speakers
280 W 330 W
100 W 130 W
91 dB 91 dB
60 Hz to 22 kHz 50 Hz to 20 kHz
Installation Instructions