Toshiba TCS-NET Manuel D'installation page 14

Installation Manual
TCS-NET GSM Phone Control Interface
Click the OPEN button. When communication between the TCB-IFGSM1E and the PC starts successfully, the
communication log appears in the textbox as shown below. If it does not appear, improper connection to the TCB-
IFGSM1E, incorrect communication configuration, incorrect TCB-IFGSM1E settings, or power-off is considered as
the cause. Examine the cause and solve the problem.
The figure shows a normal communication log between the PC and the TCB-IFGSM1E when a PIN is set.
AT+CPIN=45678 means that the PIN is set to 45678.
Setting destination telephone number, setting permitted telephone number, and specified air
conditioner name
Settings of destination telephone number, setting permitted telephone number, and the name of specified air
conditioner for test are available on this screen.
To set the destination telephone number for notification, click the INFOTEL button, enter the telephone number for
test in the Message Box following INFOTEL, and then click the SEND button.
This telephone number must be the same as the number in TEL textbox <GSM phone number> or <"+" + "Country
code" + "GSM phone number">.
When the number appears in the following message in the textbox, the setting has been successfully completed.
When a PIN is set, enter the PIN and the telephone number for test with a space separator after INFOTEL, and
then click the SEND button. **** indicates the PIN.
[SND] INFOTEL ++++ (or INFOTEL***** ++++)
[SND]OK
(+++: Telephone number for test)
To set the setting permitted telephone number, click the SETPERMIT button, enter a telephone number for test in
the Message Box following SETPERMIT, and then click the SEND button. This telephone number must be the
same as the number in TEL textbox.
When the number appears in the following message in the textbox, the setting has been successfully completed.
When a PIN is set, enter the PIN and the telephone number for test with a space separator after SETPERMIT, and
then click the SEND button. **** indicates the PIN.
[SND] SETPERMIT ++++ (or SETPERMIT***** ++++)
[SND]OK
(+++: Telephone number for test)
– 14 –
13-EN