Connect End Rail Clamps, 20" Tubing And Elbows; Connect Plain And Swedged Tubing - Radio Systems Petsafe E-Z Roof Instructions D'assemblage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Step
Connect End Rail Clamps,
1
20" Tubing and Elbows
1. Gather 4 end rail clamps, 2 - 20" tubes, 2 elbows, 2
carriage bolts and 2 nuts.
2. Insert 1 elbow into 1 - 20" tube.
3. Beginning on the gate panel side, attach 2 end rail
clamps to top frame of the kennel panel. Position
end rail clamps in the center of the gate panel.
4. Install 20" tube with elbow into end rail clamps and
tighten with 1 carriage bolt and 1 nut.
5. Repeat steps 2 through 4 on opposite side of kennel.
Loosely secure the end rail clamps to the kennel
frame.
__________________________________________________________________________________________________

Connect Plain and Swedged Tubing

Step
2
1. Gather 2 – 6" sleeves, 1 plain 53.25" tube and 2
swedged 53.25" tubes.
2. Beginning on the gate panel side, insert one swedged
tube over elbow. Place one 6" sleeve over swedged
end of tube. Insert plain tube over swedged tube
and into sleeve. Then insert remaining 6" sleeve
over plain tube. Finish by inserting remaining
swedged tube into plain tube and sleeve and over
opposite elbow.
3. Tighten end rail clamps after all tubing is assembled.
4
1-888-632-4453

Publicité

Table des Matières
loading

Table des Matières