Gisowatt LAVAMATIC TI Instructions D'utilisation Et D'entretien page 26

EN
F1 - REPLACING DUST BAG
(fig. "F1" - "F2" - "F3")
The bag should not be reused, always repla-
ce the used bag with a new one.
• Remove the plastic flange (x) from the air inlet con-
nection (y) (fig "F1").
• Take out the paper filter bag (fig "F2")
• Close the flange with the cap provided (fig "F3").
F2 - FILTER
- Model "Lavamatic" ..................: supplied
- Model "Lavamatic TI" ..............: optional
• Remove the filter (b) from the motor support (c)
(fig. " F4a").
• Clean the filter (b) frequently with a soft-bristled
brush (fig. " F4b").
• To clean the filter thoroughly, flush with water from
the inside out (fig. " F5").
• Before replacing the cartridge filter make sure it is
completely dry.
• If worn, torn or pierced, replace only the filter ele-
ment.
When the filter is wet handle with care; do not directly spray water or
do anything else that may damage it (fig. "F6").
F3 - FOAM FILTER
• Rinse the foam filter with water. DO NOT use de-
tergent.
• Replace if worn or damaged.
F4 - EXHAUST FILTERS
• Replace the electrostatic post-filters about every
two months (19).
• To release the grate covers (18) see Figure "F8".
24
(fig. "F4" - "F5" - "F6")
(fig. "F7")
(fig. "F8")
Cod.: 83 140B0K (*)
(*)
Pack code
(*)
Cod.: 83 201B0G
(*)
Pack code
Cod.: 83 035BHB
Cod.: 83 021B8X