Gisowatt LAVAMATIC TI Instructions D'utilisation Et D'entretien page 24

EN
C4 - TO WASH FLOORS
• Vacuum floors before washing.
• Vuotare il contenitore-bidone.
• Remove the filter element (if available) and operate as described in section
"D" - Extraction cleaning.
D - WASHING BY EXTRACTION
Always remove the filter element (if available) and the paper filter bag
(if present)!
Use the foam filter (Fig. "B6").
D1 - PREPARING THE APPLIANCE
Dosage
• Pour "1" dose of shampoo in the tank.
• Fill container with water up to the "MAX" level indi-
cated (fig. "D1a").
• Increase the quantity of detergent if the surface to
be cleaned is very dirty.
• Insert the container into the drum (fig. "D1b").
• Insert the detergent mixture suction hose (i) in the hole in the tank (s) (Fig. "D2").
D2 - ASSEMBLING THE DISPENSER UNIT
• Unscrew the knob (p) (fig. "D3").
• Fit the dispenser unit (e) on the ergonomic grip (9) and lock it into place in the
side guides (h) (fig. "D4").
• Screw the knob (p) back in tightly (fig. "D5").
D3 - ASSEMBLING THE HOSES
• Use the clamps (15) to run the liquid detergent hose (16) along the flexible
hose (14) (fig. "D6a").
• Plug the male rapid fitting attachment (4) into the female rapid fitting attach-
ment (5) (fig. "D6b").
• Press the front ring (6) to release it (fig. "D6c").
• Then attach the accessories and the detergent liquid feed tube, more precisely:
1- the end (7) of the flexible hose into the air inlet (8) (fig. "D7a").
2- the ergonomic grip (9) into the extension wands (10) (fig. "D7b").
3- the extension wands (10) into the spray extraction nozzle (11) (fig. "D7c").
4- the detergent solution hose (12) (attached to the nozzle "11") into the di-
22
spenser unit (13) already attached to the ergonomic grip (9) (fig. "D7d").
1 dose