Declaration Of Conformity - Bosch GEX 125 AVE Professional Notice Originale

OBJ_BUCH-1330-004.book Page 15 Tuesday, December 3, 2013 10:46 AM
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
according to the provisions of the directives 2011/65/EU,
2004/108/EC, 2006/42/EC.
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding sheets are available:
Material
– Paint
– Varnish
– Filling compound
– Filler
Expert for Wood
– All wooden materials
(e. g., hardwood, soft-
wood, chipboard, build-
ing board)
Best for Wood
– Hardwood
– Particle Board
– Building board
– Metal materials
Bosch Power Tools
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 30.09.2013
Assembly
 Before any work on the machine itself, pull the mains
plug.
Application
For sanding off paint
For sanding primer (e. g., for removing brush dashes, drops
of paint and paint run)
For final sanding of primers before coating
For coarse-sanding, e. g. of rough, unplaned beams and
boards
For face sanding and planing small irregularities
For finish and fine sanding of wood
English | 15
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
400
coarse 40
60
medium 80
100
120
fine 180
240
320
400
2 609 932 909 | (3.12.13)