Dörr SnapShot Limited 8 MP TFT Notice D'utilisation page 20

10 | MOUNTING AND DIRECTING THE CAMERA
MOUNTING
Mount the camera to a tree, pole or any suitable object using the supplied fi xing belt. Do not fi x the belt fi nally at this stage.
For security reasons you may obtain cable lock optionally. Best distance to object is 3 - 10 meters. Larger distances are also
possible, however with less reliability of motion sensor. We recommend to take a few test shots and to fi nally fi x the camera
afterwards.
DIRECTING
The camera needs to be well directed for proper pictures.
1. Hang up camera in about 0,75 - 1 m height, slightly tilting ahead. The camera lens (4) should now point to where the photo-
graphic object is expected to show-up.
2. Set the On/Off switch (9) to "SETUP" and close the camera housing. If you move in front of the camera the LED indicator (2)
is flashing red and the motion sensor is active. The red LED (2) will flash as long as you are moving within the detection area.
3. We recommend taking several test photos to see the area covered by the camera. For this purpose, turn the camera off first.
Then slide the On/Off switch (9) to "ON" position and close the camera. After 15 - 30 seconds the camera is ready.
4. Move with normal speed through detection area. The camera triggers now.
5. The picture can be viewed on the LCD display (5) directly (please refer to capture 09) or with a Laptop or PC. There are
2 options:
a) Connect the camera directly to computer using the supplied USB cord. Plug the USB cord into the Mini USB port
(11) of the camera and connect with USB port at your computer.
b) Remove the memory card from the camera and read out pictures with an external card reader (optional).
6. We recommend to direct the camera in a way that the object will be in the center of the picture. You may have to re-adjust the
camera and take another test shot.
Tip To change the camera angle you can use e.g. a small wooden wedge between camera and trunk.
7. Once the camera position is correct, the fixing belt can be tightened to hold the camera firmly
8. Switch the camera off after test shooting.
START SURVEILLANCE
Slide the On/O button (9) to "ON" position and close the camera housing. After 15 - 30 seconds camera is ready and it records
according to your settings and upon movement.
CAMERA CHECK UP
Options to check if the camera has taken pictures:
1. Open the camera housing and turn o camera. After about 2 seconds slide the On/Off button (9) to "SETUP" position.
2. The LCD display (5) shows the start screen. The lower line shows the number of pictures taken and the remaining memory.
Example: [0034/1846].
3. It is recommended to check the battery status as well. When capacity goes down, it will be more diffcult to achieve correctly
illuminated night shots. In case of doubt, replace batteries by new ones.
20