Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Adjust the arm length
1.
Loosen the screw on the arm (
2.
Adjust the length of the arm using the measure on the bottom to match the projection distance
recommended in "Positioning the Projector" on page 12 (
3.
After adjusting the length, secure the arm position temporarily by tightening the screw on
top (
).
8.
Connect the power cord and other cables to the projector
Connect any necessary cables such as the power cord, computer cable, HDMI cable, audio cables, and
USB cable to the projector.
If you are planning to run the cables inside the wall, make sure you follow all local electrical codes. If
you are running the cables outside the wall, use a cable management system to keep the cables from
).
27
).
Publicité
Table des Matières
