Furman AC-210 A E Guide De L'utilisateur page 9

Shipping charges to Furman headquarters must be prepaid by the purchaser
of the product. Furman shall, at its own expense, furnish a replacement product
or, at Furman's option, repair the defective product. Return shipping charges
back to purchaser will be paid by Furman.
CONNECTED EQUIPMENT WARRANTY: Furman's Connected Equipment
Warranty covers equipment that is damaged by transient voltage (an
"Occurrence") while properly connected through the Furman AC-210A E
to a properly wired AC power line with a protective ground in an indoor
location. Furman's Connected Equipment Warranty is limited to the amount
of the deductible on the Purchaser's personal property insurance policy
up to $500.00. In order to make a claim for this Connected Equipment
Warranty, the Purchaser must forward a copy of his/her personal property
insurance claim for the damaged equipment to Furman and complete
the Furman Connected Equipment Warranty claim form (email Furman at
info@furmansound.com to obtain the form). Furman reserves the right to
review the damaged Furman product, the damaged connected equipment,
and the site where the damage occurred. All cost of shipping damaged
equipment to Furman for inspection shall be borne solely by the Purchaser.
Damaged equipment must remain available for inspection until the claim
is finalized. The Connected Equipment Warranty is also in effect for a
period of three years unless the Purchaser does not complete the warranty
registration within fifteen days from date of purchase, at which time, the
Connected Equipment Warranty period is also reduced to one year from
the date of purchase. All warranties contained herein are null and void if:
the Furman Surge Protector in use during the occurrence is not provided
to Furman for inspection upon Furman's request at the sole expense of the
Purchaser, Furman determines that the Furman Surge Protector has been
opened, improperly installed, altered in any way or tampered with, Furman
determines that the damage did not result from the Occurrence or that no
Occurrence in fact took place or Furman determines that the connected
equipment was not used under normal operating conditions or in accordance
with Manufacturer's instructions for the connected equipment. All Furman
Surge Protectors must be plugged directly into a properly wired AC power
line with a protective ground and must not be "daisy-chained" together in
serial fashion with other power strips, UPS's, other surge protectors, three-
to-two-prong adapters, or extension cords. Any such installation voids this
9