LIFîINSTIî"UUî
Test current
Test Result: OK
2,0xle=4.04
Test of abilitv to break circuit
ln accordance with 60947-5-1a circuit was made with a resistor and choke
in series
Test details
for locking contact
Test
voltage
1,1
x
Ue
=
275VAC
Test
current
11
x
le
= 22,0
A
Cosg
0,7=45"
Number of
cycles
50 at 6-12 rpm
Test Result: OK
Test to determine
d
eoree of Protection
According to clause 5.11.2.2.1
of EN
81-20 the degree of protection must be lP4X.
The clearance shall be at least 3 mm, the creepage distances at least 4 mm and the
distances for breaking contacts at least 4 mm after separation.
Test result: OK
Examination of clearan
and creeoaoe distances
According to clause 5.11.2.2.4
of EN
81-20 the clearance shall be at least 3 mm, the
creepage distances at least 4 mm and the distances
for
breaking contacts at least 4
mm after separation.
Test result: OK
Test for resistance of leakage currents
This test is not performed but based on the values from prior tests made by the
manufacturers supplier these values go beyond the requirements of
the
EN81-50,
clause 5.2.2.4.3. The CTI value for Lexan 9404, that is used for the transparent
cover, is
225.
The CTI value for Lexan 500R, that is used for the locking contact
isolator, is 175. The minimum value requested according to the mentioned clause
is
175.
Also different literature confirm these values.
4,
Results
After the final examination the product and the technical file were found
in
accordance with
the
requirements. The functional tests passed without remarks
The load tests passed without remarks.
5.
Conditions
On the EU type-examination certificate the following conditions apply:
The door lock shall be used for swing doors only.
OLIFTINSTITUUTB.v.
NLl6-400-1002-125-07
rev.-
dare:'14-02-2017
Page4
Of
11
LIFTINSTITUUT
B
V
j
Buikstotermeerptein
381
,
P.0.
Box
36027
I
NL
-
1025
XE Amsterdam
I
NL
-
1020
MA
Amsterdam
i
Tet.
+:t
20
-
435
06
06 j www.tìftinstituut.nl
VAT
number:
i
i
Fax
+3t
20
-
435
06
26
r
contact@tiftinstituut.nl
]
NL
810399441
801
SAFTTY
AND
QUALITY
I'4ANAGEMENT